Color match small spot on g10?

[thatsteveguy]

I recently purchased a used BM tan Adamas. It's a heavy knife and I suspect that the prior owner dropped it at some point because there is a small spot on a corner of the g10 near the stop pin where it appears crushed. In that area the tan g10 turned a whitish color and my question to the forum is; what would you use to touch up the area to blend with the factory tan g10 that won't wear off? The photo doesn't really show the discoloration as it is, when I used flash it blew out the photo and my phone camera without flash leaves much to be desired. At leaset you can see the area of damage on the corner.

[/URL][/IMG]

 

[West Šenkovec]

The white thing could be epoxy or concrete dust left from a fall.
It's never gonna look like new. Sorry
Post a picture so we can see how bad it is.

You could clean the spot with alcohol and then try to sand it down with very fine wet sandpaper or scotch brite pad and try to match it with the rest. That worked well for me.

 

[sharkattacksw]

Perhaps the motto of "Cut more, worry less" fits here?