Convex grinds

[stalag2]

Yo there

Do you think it would be possible to see full height thin convex grinds made by Spyderco in a close future ?
How hard are they to make in a production run ?

Would you get one if they were available ?

I would die to get something in the 4 inches edge ballpark with a full height convex grind made in cpm m4 or 3v with dark grey / black polished micarta or g10 , 3 d machined with a deep finger choil ( just like the Streetbeat handle ), What about you ?

 

[Evil D]

Not a huge fan myself. I prefer much thinner edges than you typically see on convex grinds. I guess that all depends on the blade thickness, but then I also tend to gravitate towards thicker blades. I also don't care for sharpening them so i'll pass.

 

[CapitalizedLiving]

I'm game.