CPM3V batch

JTknives

JTknives

Joined
Jun 11, 2006
Messages
8,650
Wanted to give everyone a heads up that once the tomahawks are finished and shipped out we will be starting a CPM3V batch. I will update this post as time goes on to keep you updated. Right now I’m trying to keep the material + Cut cost down so it’s the same as what venders are charging for raw stock.

Thanks guys
 
I think it is a good ad
:D
 
I would be interested in 0.200-0.250. Need to make some choppers.... thanks JT.
 
Cool, depending on the timing I might be in for some within the .125-.187 range.

Are you still planning on bringing other steels to the website as well, not necessarily just in special run batches?
 
Yes, we use the group runs to justify and cover bulk of the steel and keep the rest in stock for normal orders. Don’t want to spend $1000+ on just bringing in a few sizes of 3v in hopes that it will all sell to individual sales.

right now we just added A2, O1 and a few others for individual sakes.
 
I actually have a 2" wide maybe .12" thick piece of that. I haven't touched it, because I don't know what the best application would be.
 
id be in on a few blanks in the 1/8" thickness
 
You must log in or register to reply here.
Back
Top