- Joined
- Jun 7, 2000
- Messages
- 188
I was just looking at the CQC6 for sale at AZCK and noticed that the pivot pin is different than the one on my 6. The pivot pin on my knife is a one piece job and screws in from the right side into the clip side. But on the AZCK's 6 it looks like the pin is a two piecer i.e. a pivot pin cap on the clip side and a screw pin on the opposite side. Not that it really matters, but which is the more common type (2 or 1 piece) and is this normal? Thanks for your input.
Mac
Mac
