CR "piggy-back" ?

[muzzleup]

451
From: Bremerton Washington
Registered: Jul 2000
posted 03-10-2001 08:55 PM
--------------------------------------------------------------------------------
During some trading, I picked up a CR Tanto1 with the 9" blade. It is impressive in the hand and I have not done much with it as yet but I do know that I would also like to have one of the CR smaller versions, say in the 4" to 5" range to go along with the big blade. I would like to see CR offer a "piggy-back" combo of say a Project or Tanto1 with a 4" or 5" model piggy backed with one double sheath.
I just built a "frog" type holder to piggy-back my Fallkniven A1 & F1 into a single carry sheath....its a nice combo.


------------------
Ron,
Bremerton, Washington




------------------
Ron,
Bremerton, Washington

[This message has been edited by muzzleup (edited 03-10-2001).]

 

[Chris Reeve Knives]

Thanks for the suggestion - all ideas go into the melting pot and who knows what might emerge!!

Piggy back sheaths tend to be a bit bulky and so we have steered away from them. In years gone by, we had sheaths made that could accommodate a steel and/or a AA Maglite but found there was a limited market for them.

Anne

 

[muzzleup]

Anne,
Thank you for your response. Yes piggyback do tend to be bulky but after carrying the one I built for my 2 Fallkniven knives I think that some people might be willing to put up with a little bulk in order to have the use of 2 different blades. This is not something I am suggesting you market,however, maybe be offered as a special order(at additional cost of course).

Thanks again for your reply.
Regards;
Ron

------------------
Ron,
Bremerton, Washington