Crosslock question.

[Bill Brent]

I've had my Crosslock for approx. 3 years and the pin has loosened up a bit and allows the blades to wobble. Is there a tool to tighten up the pins? Thanks, and by the way, this is my first post.

------------------

Billy B

 

[MAURICE]

not sure about the crosslock, im about to buyone myself soon.just wanted to say welcome to the forums.now,sit back and watch your moeny disappear.
WELCOME.

 

[Jeff O]

Welcome to the forums!
I just stuck two allen wrenches into the two holes and twisted them with a pair of pliers. It was kinda' tough to hold both wrenches, the knife, and twist the pliars but it worked. Since then I have found a pair of needle nose pliers that is small enough to fit the holes. Good luck!

------------------
Buck Collectors Club Member #1058

 

[Joe Houser]

Billy,
Welcome to the forums! Sorry to hear your Crosslock loosened up. I would recomend that you use some locktite on the threads before you tighten it up. THat should prevent this from happening again.

------------------
Joe Houser
Director of Consumer relations
Buck Collectors club Administrator and member #123