Custom dagger

M

Marko Veselinovic

Joined
Aug 3, 2020
Messages
26
Hi evrybody,

I'm a 19 year old knifemaker/bladesmith from Serbia.
Not 100% if this is the place to post this,if I'm wrong point it out.

Made this dagger during lockdown,tried to do my best.
Interested in your feedback and criticism.

Blade is made from N690co steel,heat treathed by me,guard and pommel are stainless,brass ring is hand engreved,and the wood is walnut burl.Blade and the rest of the knife is hand polished.Sheat is also made by me,hand stiched and stamped.

mONWBJF.jpg

mONWBJF

SYXi7nd.jpg

REUobNt.jpg


undefined

I will take better photos,I do have a video for now,it is better then these pics
 
Last edited:
Well done! Did you do the engraving yourself too?
 
Thanks evryone.
I didn't do the engraving my self,it was done by local craftsman who does engraving mostly on hunting rifles.I hope i will learn that one day too.
 
If you can do this well at 19 you should go far! Good luck!
 
Well, couple years have passed since I made the original post
Today I have been working on finishing up another dagger, and took a pick of it disassembled for the last time.
Tought I would share it here...
https://imgur.com/acFha9L
blade is N690 steel, 18cm (~7inch)
gaurd and pommel are stainless, cooper ring and "damascus" G10

While I am here, I will also share a pic of the more or less same knife, just the ring on the handle is wrought iron and insted of G10 walnut burl was used.
https://imgur.com/5VtbPMA
 
Last edited:
You must log in or register to reply here.
Back
Top