Cutter17's Tyrade low rider replacment clip

[STR]

Cutter17 I can't figure an easier way to reach you than to just post it.

Its done. Just waiting on the address to arrive here in the mail to mail it out now.

Should do the job. Worked great on my own Tyrade for tip down carry.

STR

 

[jack lowe]

how much does a clip like that run?

 

[STR]

All my custom low rider clips are $30 plus shipping back to you.

Only when I have the knife here can I do them like this where I don't need your folder to do one up for you.

Read the sticky post top of the page on every page in my forum in my low rider pocket clip info thread and mailing instructions for more.

Thanks for asking.

STR

 

[cutter17]

VERY COOL!! Thanks STR. I'll be mailing out payment today or tomorrow. My mailing address is;

Rick Davis
184 Monfredo St
Rutherfordton, N.C. 28139

 

[cutter17]

Hey STR, m.o. has gone out USPS Priority mail so you should get it on Tuesday! Thanks again.

Btw, I have a clip I made for my Strider AR. Made from a steel clip that I had laying around. If I send it to you can you duplicate it in titanium?

 

[STR]

Yours shipped out. I'll pass on the Strider clip. Thanks for asking though.

STR

 

[cutter17]

Hey STR, clip came today and it is total perfection! Thank you so very much for making it possible for me to add an exciting knife to my edc rotation.:thumbup::thumbup: You 'da MAN! Btw, I did a little more write up of the clip over in the Kershaw Forum.