damascus dagger

K

Karl S

Joined
May 16, 2007
Messages
7
folks,

I'm a newbie in your forum and I like it. A lot of fantastic informations and pictures.

I'd like to give you a short introduction to myself: I'm living in Germany and bladesmithing is one of my hobbies.

Today, I want to show you a dagger which I made in 2007.

overall length: 8.27 inch
blade length: 4.33 inch
handle: plum wood with red fiber and brass
I forged the blade out of two different carbon steels


ga8ovron.jpg


I hope you like it and thanks for looking.

Karl
 
Hi Mackenzie4856,

May be.
Here is an other picture which I have on my laptop. But If you want to see more pictures from different angles then I have to make some new pictures. Sometime in the next days.

6yhc5zb2.jpg


The intension behind this special handle is to transfer the square profile from the blade into a round handle

Karl
 
Love the dagger, wish I was that advanced at knife making but the sheth doesnt really match the knife?
Just my 2 cents
 
I think that carved handle is different..I like it. Looks reall good all around! Did you make the sheath?
Paul
 
@PMLKnives:
Sure. I think it is my third or fourth one

@all
I'm happy that you like it

Karl
 
You must log in or register to reply here.
Back
Top