Deluxe Joker's Wild Pearl.

[gstmkr007]

Deluxe Joker's Wild Pearl.

This is a nice example of my joker..I decided to spice it up a little with some presentation grade white lip pearl! I pushed the grind back to get more edge and flame fileworked it all around. The Pearl has peened german silver pins
and I hammered copper into the cuts I normally use to wrap these. It will have a kydex neck sheath and chain unless the buyer wants something special made up for it.

OAL: 6 3/8"
Blade steel: S30V .150 thick
Blade length: 2 1/2"
Cutting edge: 2 1/4"
Lanyard hole: 1/8"
Handle: Whitelip MOP.
Flame filework.


Thank you for your interest in my knives!

Brad Fairall

www.fairalldesigns.com

 

[Kevin Jones]

You have some very nice looking knives on your website.

The design on this one is interesting. What's with the two red dots?

 

[gstmkr007]

Hi Keven,

Thank you.

I designed the joker to be a cord or line wraped handle, so before heat treatment I cut a slot with the band saw and then milled a small divot at the end on one side to accept the knot. All 25 were done that way...so I hammered and packed copper into the slot and divot to fill it rather than just leave it open when I decided to handle it in pearl. I thought about wrapping both ends with silver wire, but I thought it would add too much weight for a neck knife.

Also, It cost me $25 in carbide to drill those 2 pin holes...that S30v is at 59-60 RC . I grind finish and filework all my knives after
hardening!