- Joined
- Aug 12, 2002
- Messages
- 2,259
OK, have an Endura II that I'm probably going to sell. Was my EDC for a while, so got used hard, and had no problems of course(it's a spydie, come on). Went to a Delica for EDC though, to be more sheeple friendly.
ANyways, thinking I may sell this one now, but there's some little dings, etc in blade. Tyupical of a blade used by a techy, cut misc. copper wire, etc. ON a plain edge, would just use stone, sharpmaker or grinder until these were gone. Not quite sure what to do to deal with these on the Spyderedge though. Want to of course get this knife in as good condition as I can before I sell it, to give best knife to future owner, just not sure how best to go about it.
ANyways, thinking I may sell this one now, but there's some little dings, etc in blade. Tyupical of a blade used by a techy, cut misc. copper wire, etc. ON a plain edge, would just use stone, sharpmaker or grinder until these were gone. Not quite sure what to do to deal with these on the Spyderedge though. Want to of course get this knife in as good condition as I can before I sell it, to give best knife to future owner, just not sure how best to go about it.
