Do I make this or scrap it.

blindhogg

blindhogg

Joined
Feb 21, 2001
Messages
1,002
Alright guys I need some advice, I am trying to decide on a few models to have water jet cut and this one is on the fence.
I cant decide if I like it or it looks like something you would see at the knife show for $7 because its made in China.
Specs are, 7" total length, 3" blade and 1" diameter finger holes. It would sell for $75-$80 w kydex.
So the big question is if you saw it would you purchase it or pass??????????
Thanks
Chris W.
knife6.JPG
 
I would be more likely to buy one if the finger notches were less pronounced.
 
What program did you use to design this?


And looks good only thing is that I think at the end of it there should be another much smaller maybe even flat finger grove. Just so that its nice to let the pinky finger sit there. IMO its nicer to have a knife with a straight but then a rounded one because of this, even if its not that small with a cord rap it would look and feel better.

Thats just what I think though.
 
looks pretty good chris, could i come up with some sort of angle about it being the newest thing in kitchen knives?
scott
 
You must log in or register to reply here.
Back
Top