Does a Kershaw Leek clip fit the Cold Steel Air Lite?

Daniel L

Daniel L

Gold Member
Joined
Nov 2, 1998
Messages
1,978
I like the Air Lite, but I don't like shiny clips and I really prefer deep carry clips.

Looking at the pics, is there any chance that the clip hole spacing on the Cold Steel Air Lite is actually the same as a Kershaw Leek (which have ready supplies of after market clips.)

Does anyone by any chance own both and can confirm / deny?
 
Tagged. Was wondering the same. Leek, Blur clips are the same. I hope they fit.
 
There has to be an Air Lite owner out there who owns a Leek or a Blur :)
 
Slightly modded a Leek/Blur tip down deep carry clip to almost fit flush on the handle. Tip down clips for the Leek/Blurs tend to have a shorter length between the screw holes and clip bend. It will not hang off as much.

I also lengthened the finger groove a little to give my thumb more purchase on the stud.

5e2Lyuw.jpg
 
j-vtol said:
Slightly modded a Leek/Blur tip down deep carry clip to almost fit flush on the handle. Tip down clips for the Leek/Blurs tend to have a shorter length between the screw holes and clip bend. It will not hang off as much.

I also lengthened the finger groove a little to give my thumb more purchase on the stud.

5e2Lyuw.jpg
Click to expand...
Nice mod!
 
What did you do to make this clip fit? I've been holding off on this knife because I don't like the clip it comes with.
 
nm13 said:
What did you do to make this clip fit? I've been holding off on this knife because I don't like the clip it comes with.
Click to expand...
I extended the screw hole over with a dremel to match up. Then used small needle nose pliers to tighten the screw since a torx bit was hard to use. Seems silly but it worked.:thumbsup:

You might be able to find a more narrow deep carry clip to mess with. Pops custom clips?

2GDEl35.jpg
 
You must log in or register to reply here.
Back
Top