does anyone have a good pattern for a small 8"-10" thrower?

[richard j]

i have some 3/16 1075 that i'm going to use for throwers only. i'm going to make about 6 for him. i would also like a pattern for one around 12"-14" long. thanks.

 

[Nixelplix]

Do you want to make them single-edged or double-edged? I like making them single edged, so I don't have to worry about the blade symmetry that much.

 

[richard j]

double edge is what i was thinking of. the bottom one looks about the right size. i was wanting a pattern i could print up and transfer to the steel.

 

[Nixelplix]

That sounds cool. What I would do in this situation would be to draw half of knife, then scan it, copy and flip it, and put the two sides together for symmetry.