- Joined
- Sep 5, 2013
- Messages
- 1
I made some scales for my Rat 1 and messed up a few of the screws and driver bits too! I contacted OKC and they were great. They didn't have much there and didn't know the exact size, but offered to send me some screws they had for free. The only problem was that they were for the belt clip which are slightly longer and would not work properly. I've looked around town everywhere and came up with nothing. I've searched the internet and haven't found anything helpful either.
So I took a shot and ordered some 2-56 T6 screws that were (.170 in length) from knifekits.com. The thread and head size and length were spot on, but the the shaft itself was not thick enough looked like it needed to be another mm or so in diameter. I'm pretty sure the thread count is right at 56, and the length is good, but I cant figure out the rest. Can someone please help me that might have been here before? I would really appreciate it! Thanks!
So I took a shot and ordered some 2-56 T6 screws that were (.170 in length) from knifekits.com. The thread and head size and length were spot on, but the the shaft itself was not thick enough looked like it needed to be another mm or so in diameter. I'm pretty sure the thread count is right at 56, and the length is good, but I cant figure out the rest. Can someone please help me that might have been here before? I would really appreciate it! Thanks!