- Joined
- Nov 17, 1999
- Messages
- 676
Hello Folks,
For all off you who don't have the money to buy expensive stuff to make serrations, here's an easier way.
1. If you don't have a dremel, get one.
2. buy the chain-saw sharpening tool (8.5 $). It has 3 cylinder shaped stones, 3 mm, 3.5 mm and 4 mm. Very wear resistant, good for bigger serrations.
3. Buy a small (1mm) thick cylinder shaped diamant engraving bit, and a 2.4 mm head.
4. Now you clamp you knife, practice a lot, and after a few times, you can make excactly the same serrations as on a spyderco.
greetz, bart.
For all off you who don't have the money to buy expensive stuff to make serrations, here's an easier way.
1. If you don't have a dremel, get one.
2. buy the chain-saw sharpening tool (8.5 $). It has 3 cylinder shaped stones, 3 mm, 3.5 mm and 4 mm. Very wear resistant, good for bigger serrations.
3. Buy a small (1mm) thick cylinder shaped diamant engraving bit, and a 2.4 mm head.
4. Now you clamp you knife, practice a lot, and after a few times, you can make excactly the same serrations as on a spyderco.
greetz, bart.