Drop point EDC - M398

[navman]

One off drop point EDC partial tang in M398. This one features a 3 inch blade ground from 1/8" thick M398, heat treated to 64-65 HRC by Peters', with a sweeping plunge. Overall length is 7.25 inches. The partial tang was tapered and backed with black canvas micarta. The scales are black and green canvas with red liners. The handle is secured to the tang with three titanium pins and system 3 epoxy, the pins were lightly peened. It also features a decorative pin and brass lanyard tube. The blade is flat ground to .008 BTE thickness prior to sharpening.

Rides in a hand sewn pocket clip sheath in black leather with red thread.

 

[Dawkind]

That’s an exceptionally fine ensemble right there my friend…

 

[Retired UPS Driver]

One off drop point EDC partial tang in M398. This one features a 3 inch blade ground from 1/8" thick M398, heat treated to 64-65 HRC by Peters', with a sweeping plunge. Overall length is 7.25 inches. The partial tang was tapered and backed with black canvas micarta. The scales are black and green canvas with red liners. The handle is secured to the tang with three titanium pins and system 3 epoxy, the pins were lightly peened. It also features a decorative pin and brass lanyard tube. The blade is flat ground to .008 BTE thickness prior to sharpening.

Rides in a hand sewn pocket clip sheath in black leather with red thread.

That’s a real beauty, including the sheath, very well done

 

[jfk1110]

Nice blade and pants!

 

[Kevin W.]

Josh, I'm going to need that build in this pattern. Aaaand Go!!!