navman
Knifemaker / Craftsman / Service Provider
- Joined
- Mar 4, 2013
- Messages
- 2,805
It has been a while since I've posted any pictures, mainly because I am no where near my shop (which is in storage). This one was made a few years back and has been sitting in a pelican case.
Several years ago, when stationed at EODMU8 I began making knives to be auctioned for EOD Warrior Foundation, raising funds for the families of EOD techs killed or wounded in action. A friend and EOD Tech contacted me from EODMU5 in Guam and asked if I would be willing to do so again. I contacted my wife back in the US and had her pull this one out of the storage case. It will be sent to Guam to be engraved and auctioned for the benefit of the EOD Warrior Foundation. Unfortunately, only have a crappy cell phone pic from the wife, but here are the specs:
Full flat ground .156 thick AEB-L, with a 400 grit satin finish and rounded spine.
OD Green G-10 with blue G10 liners
Brass pins and tube.
Several years ago, when stationed at EODMU8 I began making knives to be auctioned for EOD Warrior Foundation, raising funds for the families of EOD techs killed or wounded in action. A friend and EOD Tech contacted me from EODMU5 in Guam and asked if I would be willing to do so again. I contacted my wife back in the US and had her pull this one out of the storage case. It will be sent to Guam to be engraved and auctioned for the benefit of the EOD Warrior Foundation. Unfortunately, only have a crappy cell phone pic from the wife, but here are the specs:
Full flat ground .156 thick AEB-L, with a 400 grit satin finish and rounded spine.
OD Green G-10 with blue G10 liners
Brass pins and tube.
.