Early Lock Up After Reassembing My Regular Seb

[Evany]

Took my Large Reg apart recently to clean and lube with CRK grease. When I put it back together it seemed to function nicely, but then I noticed that the lock bar is just barely engaging with the blade, maybe 10%. The blade seems solidly locked, but I'm concerned that with such minimal contact it could possibly be unsafe. Before I took it apart the lock up was probably at 25%. Should I overhaul it again, or is an early lock up like this acceptable, or even a good thing?

 

[Schmidt75]

I'd flick it open 10+ times and see if there is a difference.

 

[Nikkogi]

I would take it apart, rotate the stop pin, and reassemble

 

[Humint]

I would take it apart, rotate the stop pin, and reassemble

Try this. This has worked for me in the past

 

[Evany]

Will try rotating the stop pin. Thanks!

 

[Ernie1980]

Also try opening it with a little force once just to make sure everything is set into place.

 

[Muaddib1116]

Sometimes swapping the barrel nuts around can change the alignment a little.

 

[clockman]

Email sent about how to change the lockup %. It worked for me.

 

[Evany]

Rotated the stop pin and applied slight torque to the slabs as described by clockman. Lockup is just right now at about 25%. Thanks everyone!