EDC UG Damascus Sebenza

Status
Not open for further replies.
rexromic

rexromic

Gold Member
Joined
May 28, 2011
Messages
5,255
I'am in a process of purchasing Large UG Damascus Sebenza, for EDC.Just wanted to see if anyone also uses theirs.Been thinking for a while,because they are very nice looking blades.Please chime in with pics too so I will not feel so guilty after all ;).Thanks all.
 
Not a UG, but I just bought a Plain Jane large 21 Ladder Damascus from Techno that is going right into my pocket to bump my Large 21 Micarta Insingo out as soon as I get it tomorrow. Heck, I might just carry both.:)
 
Mine is also not a UG, but rather a Plain Jane Large 21 Basketweave. I've carried it every day, save for a couple, over the last few months, and the blade still looks new. The handles show the usual light snail trails. CRK Damascus makes for a great EDC blade, IMO. I used it the last couple of days to cut and strip a bunch of RJ-11 cable to prep for making short cables, as the available wire strippers were too finicky to use on the flat cable. Within a few minutes on the fine side of a Spyderco DoubleStuff, the edge was as sharp as before.

I would strongly recommend that you go for it!
 
socom1970 said:
Not a UG, but I just bought a Plain Jane large 21 Ladder Damascus from Techno that is going right into my pocket to bump my Large 21 Micarta Insingo out as soon as I get it tomorrow. Heck, I might just carry both.:)
Click to expand...

I need to figure out a way to comfortably carry both my Basketweave Sebenza and Umnumzaan much the same. Two CRK's would make for a good day.
 
Not exactly an EDC, but I do carry and use this one on occasion. The blade takes a super keen edge and holds up just as well as the regular stainless blades.
 
Ah, cool. I'll be similar, but not identical. Post pics when you get it!
 
Here's my present edc. Apart from the etch fading a bit near the stud it's holding up just fine.
DSC_0058.jpg
 
Status
Not open for further replies.
Back
Top