Endura deep pocket clip

R

rmeron

Joined
Sep 28, 2011
Messages
399
I've noticed all the deep pocket clips I've seen for the Endura only have two screw holes, is that the normal or does someone make one with three holes that fit properly?
 
There are three attachment points on the Casey Lynch clips. In a lot of the photos only two of the screws are visible. It'll make sense when you go to install one. The top screw must be inserted at quite an "angle" through the hole in the face of the clip.
 
Yep. Casey is gtg!!

c783adfa739b3abaeb5a06e473e54515.jpg
 
How long does it take Casey to respond to a message. I sent him one this morning about one for my Endura. I'm probably getting to anxious.
 
Would just two screws be enough to hold the clip?
knifeneasy said:
There are three attachment points on the Casey Lynch clips. In a lot of the photos only two of the screws are visible. It'll make sense when you go to install one. The top screw must be inserted at quite an "angle" through the hole in the face of the clip.
Click to expand...
 
rmeron said:
Would just two screws be enough to hold the clip?
Click to expand...

I don't have one of Mr. Lynch's pocket clips, but on one of my knives with the 3 screw pocket clip i only have 2 in there. I put them on the outside and left the middle one empty. Works just fine.
 
Will I be able to put a lanyard on my Endura after I install Casey's deep pocket clip?
 
No problem. One thing I remember about putting that lanyard on was that in order to not defeat the deep carry nature of the clip I had to hollow out the paracord. The box knot requires this so it was a natural fit. Permanent attachment would also lesson the impact (no doubled up cord going through the hole).
 
How about a few more, because who doesn't like pictures? OP, when you get yours, be sure to post some pics!

dj2ppmnh.jpg

Ll1lGmBh.jpg

jkRZ5Xfh.jpg
 
Like I said before, as soon as I can get my daughter to use her camera they will be posted.
 
You must log in or register to reply here.
Back
Top