Engraved Cigar Cutter

M

Mike Fennessy

Joined
Dec 19, 2005
Messages
326
I didn't make the cigar cutter, but I engraved this for my brother for Christmas. Just finished it last week. Our unorganized family has Christmas around the end of January :rolleyes:

I also finally got a decent (used) camera set up.

Thanks for looking.

IMG_3899sm.jpg
 
He should be extremely pleased with that, no matter which Christmas it's for. :D

Beautiful job....I like the way the direction changes from one end to the other. :cool:
 
Thanks everyone. The other side has the scrolls going in the same direction so I could compare the two. These are a good size to practice on, so I'll be getting some more. They're too small (for me anyway) to sketch a design on paper and then transfer it to the piece so I have to design as I go, which is great practice for me.
 
Hey Mike, How much would you charge to practice on the bolsters of one of my knifes ? That looks GREAT.. p.m. me if you are interested in doing some engraving... thanks.
 
Mike: You dressed that up finely. Nicely done. :)

Do the maker a favor and tell us who made it?

Thanks.

Coop
 
Coop, It was a cheap cutter from Amazon. It's just a step between scrap steel, which get's boring, and my folders, which I didn't quite feel ready to do.

Jim, yeah, I'd be interested. I'll send you a pm.

Thanks again everyone :)
 
You must log in or register to reply here.
Back
Top