Engraving a Sebenza

BoilerUp17 · Mar 20, 2016

Hi all I know this has been covered before at least at brief so I apologize for the repeat. I would like to get an engraving on my 25 and was wondering if CR would do a custom job as apposed to a basic model already produced. I'd really like it if someone could tell me how this would look, so some examples would be great, as I'd prefer a pretty detailed job as apposed to a basic scene. Some suggestions beyond CR would be good too. Id like to get my initials on it as well and I know some of you have done this. Thanks for the input.

Corytr · Mar 20, 2016

A search found these courtesy of rexromic and Falco

Corytr · Mar 20, 2016

One from lisantica. Two of the images were borrowed from: http://www.bladeforums.com/forums/s...sebenza-engraving?highlight=engraving+sebenza

Check this one out also: http://www.bladeforums.com/forums/s...he-hook-graphics!?highlight=engraving+sebenza

BoilerUp17 · Mar 20, 2016

Any ideas where I could get something like this done with the current knife i have, I don't know if anything CR would do would be as detailed.

Corytr · Mar 20, 2016

You ought to try a Google search for 'engraving forum'. I believe some master engravers hang out in some of those forums.

SlammedM3 · Mar 20, 2016

That's a great looking knife. Watched it on YouTube. In her comments it was around 1200. Was done by Tim George.

tshoot · Mar 21, 2016

Corskin said:
One from lisantica. Two of the images were borrowed from: http://www.bladeforums.com/forums/s...sebenza-engraving?highlight=engraving+sebenza

Check this one out also: http://www.bladeforums.com/forums/s...he-hook-graphics!?highlight=engraving+sebenza

Wow, that is stunning!! Do they do anything with the clip side?

Falco57 · Mar 21, 2016

Corskin said:
A search found these courtesy of rexromic and Falco

Thank you Corskin!

I never seen a Seb 25 engraved by CRK, mine was from an Italian Engraver

SlammedM3 · Mar 21, 2016

Quite the detail falco!! Looks amazing. How deep does it go into the scale though?

Falco57 · Mar 22, 2016

Should be 0,2mm, no more than 0.5mm

Kilo11 · Mar 22, 2016

View attachment 623761

:d

Jubakuba · Mar 22, 2016

This dude works for Custom Knife Factory...
I've yet to get my one-off CKF in the mail, but his engraving is gorgeous if the pictures are anything to judge by.

If you ask him he'll do it for you I'm sure, but be prepared to ship to Russia and back.

https://www.instagram.com/sbknives/