- Joined
- Oct 6, 2000
- Messages
- 567
I think I'm gonna get my dad a Buck 110 for Christmas...since it is my last official Christmas at home (leaving for Basic 1 week later), I would like to have it engraved...I've never done this before and really have no clue as to what would not look corny and what to put on it...
http://www.buckknives.com/products/details.php?ID=47
With the knife 'standing' vertically, I was thinking of putting his initials horizontally across the top bolster (the one by the blade), and then something on the bottom bolster, like this:
Merry
Christmas
12/15/02
Is that too long? Not good enough? Something better? Help?
So I can go to a jeweler and they can do this? About how much would it cost? Can you choose between a few scripts?
Thanks,
Warthog
PS - I've checked out Pete's Custom Knife Shop already...all I want is a normal, classic 110 with engraving
http://www.buckknives.com/products/details.php?ID=47
With the knife 'standing' vertically, I was thinking of putting his initials horizontally across the top bolster (the one by the blade), and then something on the bottom bolster, like this:
Merry
Christmas
12/15/02
Is that too long? Not good enough? Something better? Help?
So I can go to a jeweler and they can do this? About how much would it cost? Can you choose between a few scripts?
Thanks,
Warthog
PS - I've checked out Pete's Custom Knife Shop already...all I want is a normal, classic 110 with engraving
