ESEE 3 Handle Swap - what size driver?

H

hammerface

Joined
Mar 28, 2004
Messages
297
Hey all - this is probably a stupid question from my fried brain being it's a friday but thought I'd better ask instead of f-ing something up. I just got 2 different 3Ps in today and I would like to try swapping the handles (orange G10 and canvas micarta). I for the life of me can't find the right size allen wrench to fit 'properly'. can anybody tell me the actual bit size I should be using?

On a side note - these 2 knives are absolutely awesome :) (I also got a 5 in today as well - will post pics later :)
 
Last edited:
I thought it was a torx bit....8 or 10? Am I thinking of something different?

I guess my handles were for the Izula....not sure what the bigger blades use.
 
both my 4s and Izula scales all use 3/32"
(and the short chicago screws for the kydex sheaths also fit the scales)
 
Go figure - I think I have every size but the ones I need :grumpy:

I have an entire set of hex bits but they're all metric...dammit...

I too was second guessing myself if they were torx or hex - but I tried all my torx bits and nothing fit very well either. Have to hit the hardware store tomorrow or something..

THanks for your input guys
 
You must log in or register to reply here.
Back
Top