I've come upon a way to increase my carry options with the Fang neck knife by at least four and I'd like to share it with you folks. It only took about ten minutes to do and I think some of you who haven't thought of it already will like it as much as I do. What this mod does is allow you to carry the knife with a 45-degree cant in any direction, upright or inverted.
All I did was drill an extra hole in the clip, midway between the two lower holes (with the open end of the clip pointing downward) and approximately 1/8" above the centerline of the other holes. Rather than trying to measure it all out and try to keep everything straight, I laid the sheath on top of the clip and marked the drilling location with a permanent marker. I only had one shot at this since I only have the one clip that came with the knife, but everything came off beautifully.
Here's a link to the pictures I promised.
www.workingwebdesign.com/knives
Thanks again Bob for a wonderful product!
Regards -- Shades
All I did was drill an extra hole in the clip, midway between the two lower holes (with the open end of the clip pointing downward) and approximately 1/8" above the centerline of the other holes. Rather than trying to measure it all out and try to keep everything straight, I laid the sheath on top of the clip and marked the drilling location with a permanent marker. I only had one shot at this since I only have the one clip that came with the knife, but everything came off beautifully.
Here's a link to the pictures I promised.
www.workingwebdesign.com/knives
Thanks again Bob for a wonderful product!
Regards -- Shades