Question Feedback at Knife Exchange

[ChazzyP]

I've looked through the threads at Tech Support and have not found this issue raised, so I'll post here and hope someone has an answer....

I've had a couple transactions that were not done through BF--a knife scale purchase from a registered Service Provider and parts received from the CS of a listed Manufacturer. The aforementioned Feedback area is where threads regarding such transactions would normally be posted.

When I go there I find a "you do not have sufficient privileges" note where the Start Thread button would normally be. Is this area temporarily or permanently closed, under re-construction, or what?

Both the parties I've mentioned certainly deserved thumbs-up for their service and products and I'd like to be able to provide that for them.

Thanks,
CP

 

[Spark]

If it was done off BladeForums, you can't leave feedback for it. You can start a Feedback thread for that person, but actual XenTrader Feedback requires a valid thread in one of the designated Exchange forums that both parties have participated in.

 

[ChazzyP]

Thanks for the reply, Spark. I wasn't trying to leave XenTrader Feedback, as I know that can't be done without the Exchange thread. I was trying to create a thread here, as I have in the past for similar transactions. That's where I got the "insufficient privileges" button at the bottom instead of Start Thread.

 

[Kiah]

Yeah, permissions are still wonky in the Feedback forum. I can't start a thread there either.

Since it's somewhat related, ATG and KMG have permission issues as well.

 

[Spark]

Try posting a feedback thread now.

Kiah, I'll look at ATG & KMG

 

[Kiah]

Feedback forum working for me now. :thumbup:

 

[ChazzyP]

Works for me too, Spark. Thanks for the fix and for all you're doing to make this place even better.

 

[Spark]

Knifemaker's areas should be working.

 

[Kiah]

All good. :lots of thumbsup:

 

[Spark]

Closing thread then.