Feedback on this?

i will tell you that there is a error in that some where. Either the omega spring have been disabled or broken. It is not possible for the axis lock to fail unless there is omega spring error or stop pin is bad (too big) cause faulty lock up. This is an easy fix for BM. They will replace for fix for free. Not an issue with any of 100 + axis locks that I have owned. I have an axis lock that I have used and beat on for 2 years. It was previously owned and used before I got it. I have taken it apart and pimped it out a little and never had an issue.......EVER...
 
*sigh* Here we go again.

If he held the knife at the very rear of the handle, I might buy it, however it is too easy for him to use his thumb to release the axis lock. Sometimes the most important things on the YouTube vids is what you don't see.
 
A.P.F. said:
*sigh* Here we go again.

If he held the knife at the very rear of the handle, I might buy it, however it is too easy for him to use his thumb to release the axis lock. Sometimes the most important things on the YouTube vids is what you don't see.
Click to expand...

I'd have to agree, it looks to me like his thumb is AWFUL CLOSE to the axis release...

The 2 axis locks i've owned have been ROCK SOLID.
 
You must log in or register to reply here.
Back
Top