Fenix L1S question

[rebeltf]

Hey folks.

Was doing some reading on Fenix site about my L1S and it said there are two modes of operation , high and low output , but I cant figure out how to get the low output.

Does anyone know how to make it work in low ? I cant seem to find my manual or one online ( to be honest I cannot recall if I got a manual with the light or not. )


Thanks in advance.

 

[rickppoole]

The review below says to make sure the head is on tight for high output mode and to unscrew the head slightly for low output mode.

http://www.flashlightreviews.com/reviews/fenix_l1s-l2s.htm

 

[xdshooter]

My P3D has a little quirk, it doesn't like to be started on TURBO (their word not mine). It sometimes goes into a flicker mode. But with such a short run time on turbo, I leave it on low most of the time anyway.

 

[rebeltf]

The review below says to make sure the head is on tight for high output mode and to unscrew the head slightly for low output mode.

http://www.flashlightreviews.com/reviews/fenix_l1s-l2s.htm

Thanks !

That's the ticket.