First boker (epicenter) clip issues.

[not-too-sharp]

So in my search for another Ti framelock to add to the edc rotation, I stumbled onto the boker epicenter. I haven't had any bokers before but the reviews I read here and elsewhere were promising, and I got a heck of a deal from a local dealer. The knife is exactly what I'm looking for and the overall quality/fit and finish are top notch. The only issue is that the pocket clip moves about a 1/4 inch in either direction even when the screws are tightened all the way down. It was fine at the store when I purchased it but after I switched it to tip up carry I noticed the clip was in a different spot every time I took the knife out of my pocket.
So these are my questions:
Is this a common issue with the epicenter?
If it is, what is the solution?
If this is a lemon, will boker fix it?
Sorry for the long post and thanks for any help in advance -Andrew

 

[GCG199]

I don't recall having to move the pocket clip around on my Boker Plus Epicenter.

So it came tip-up.

You probably need to look into getting some Locktite and try using that to see if it keeps the pocket clip locked down.

If that doesn't fix it, then it would be a good idea to contact Boker about it.

 

[cutter17]

Haven't heard about any issues with the Boker clip on the Epicenter. But if it moves, the screws must not be fully tightened. Of course you have to be extremely careful when you tighten the screws as it is possible to snap the heads of the screws off. GCG is right on the money about using Loctite, just be sure to get the blue.