- Joined
- Aug 11, 2001
- Messages
- 347
I have a folder that I love but just noticed a little flaw. the grind on one side doesn't match up with the grind on the other side by about 1/8 of an inch. I'm not too concerned with sending it back as it is a hard user and I have voided the warranty a long time ago.(I just gotta take em a part and mess around with em) anyway it locks up tight and holds a razor sharp edge so i'm not too concerned except for the fact that the way it is ground the last 1/16 of an inch or so is thick, blunt and uneven. how do I straighten that out. can I just use a sharpmaker and go over it a million times? its cpm440v steel so its kinda hard to do that. any other suggestions?