Just bought a Fallkniven P1 folder with 3G steel.
I've notice that clad is not symmetrical: i.e. the line that marks the point where SGPS steel "comes out" of VG2 steel, is not equal onboth sides of the blade.
In addition to this cutting edge profile suffers from same "disease": on one side the angle is noticeably steeper than on the other side.
Was this meant by FK or just happened in the manifacturing process?
Had any other fellow here experienced same issues?
I've notice that clad is not symmetrical: i.e. the line that marks the point where SGPS steel "comes out" of VG2 steel, is not equal onboth sides of the blade.
In addition to this cutting edge profile suffers from same "disease": on one side the angle is noticeably steeper than on the other side.
Was this meant by FK or just happened in the manifacturing process?
Had any other fellow here experienced same issues?