Form sent

[dustyzz]

I submitted an order form for a deep carry PM2 clip... the form had "hand rubbed finish" as an option (my preferred selection), however the instructions stated that the finish choices were anodized and bead blast... if hand rubbed finish is not an actual available option, then I would like to amend my order for bead blast finish.

Thx,
J.R.

 

[STR]

I submitted an order form for a deep carry PM2 clip... the form had "hand rubbed finish" as an option (my preferred selection), however the instructions stated that the finish choices were anodized and bead blast... if hand rubbed finish is not an actual available option, then I would like to amend my order for bead blast finish.

Thx,
J.R.

Thanks. Yeah it was a mistake to list that finish for the clips. I've only done it for the pry bars. Mostly it is due to the level of difficulty to clean it up. This recent batch of ti was so dirty and some sections had what are still minor scratches but deep enough to be a long while getting out so this batch is a no go for hand rubbing I think. Bead blast cleans it right up and I kinda have to do it anyway so I think for the time being that will be the main finish and anodizing on top of that. Fortunately that finish is not called for all that much anyways. Thanks though
STR