frn clip width??

Hmmm! I didn't know this. Clip width or shape?

I don't have my old Endura here to compare with the one I bought from Razor recently (it HAS to be newer than my old one).

The one I'm looking at has straight sides to the clip (not curving inwards in the middle like I seem to recall my old one might have?), and the base area is just under 6/16" wide tapering down to about 5/16" at the tip.

Or maybe the shape change is a figment of my imagination. :)

If there was a change of width or shape, was it supposed to prevent the likelihood of broken clips?

Ya got me interested in this!

Karl
 
Hi Safety Guy. The FRN clips on the Endura dn Delica were changed 6 times over the course of 8 years. Each change was a small improvement over the one before. The width was modified in about half of these mold changes.

sal
 
You must log in or register to reply here.
Back
Top