- Joined
- Aug 2, 2004
- Messages
- 18,850
I just finished this one up today.
Its made from Aluminium rather than Ti this time but to be honest Ali is nearly as good but much less expensive.
It does scratch up far easier than Ti and dosnt have the advantages of heat colouring but functionaly its just the same.
The spacer is a full ring and full back spacer that hugs the stop pin so it gives the kerambit a real nice clean look to it.
I also added a lanyard hole, the hole is already there in the Ti liners so I just expanded it and drilled it through the spacer and scales.
A skull fob or something does look pretty good and dosnt really get in the way either so there is no harm in having it.
The spacer only adds 6g to the weight of the knife (the original spacer is 6.3g and the new one is 12.4g)
:thumbup:
Its made from Aluminium rather than Ti this time but to be honest Ali is nearly as good but much less expensive.
It does scratch up far easier than Ti and dosnt have the advantages of heat colouring but functionaly its just the same.
The spacer is a full ring and full back spacer that hugs the stop pin so it gives the kerambit a real nice clean look to it.
I also added a lanyard hole, the hole is already there in the Ti liners so I just expanded it and drilled it through the spacer and scales.
A skull fob or something does look pretty good and dosnt really get in the way either so there is no harm in having it.
The spacer only adds 6g to the weight of the knife (the original spacer is 6.3g and the new one is 12.4g)
:thumbup: 
