Full RS for HD-7

[Lycosa]

Hi Steve,
Bet yer busy. If you work on a HD-7 at some point, please make me a rear spacer that fills the whole butt of that knife. Is the CQC-7 butt the same? That might make it easier for you. No rush. Let me know if you have any Q's. Thanks!
Lycosa-Rolf

 

[STR]

I've already looked into this for someone else. I don't recall who at the moment but I do recall that the rear spacer thickness is much greater than anything I stock. Its thicker than my thickest titanium or G10 by quite a bit as I recall.

STR

 

[Lycosa]

Is that .185 G-10 I sent down too thin? I thought that was the correct thickness? Let me know. NO rush! Thanks Steve. Hope Yer well.
Rolf

 

[STR]

I didn't measure that sheet. I guess I didn't catch that you wanted me to use it for that. I don't have an HD7 any longer so I'd need the knife to make that spacer for the rear.

STR

 

[Lycosa]

Stevo,
That rear spacer for the HD is low on my priority list especially since I'm carrying my P-Mil. now. If you get a HD-7 in or a CQC-7, if that model works, please let me know. IF you need the knife to do the work, I'll send it at a later date. Yer too busy to mess with this! Thanks!
Rolf