g10 endura - waved

[mark greenman]

Would it be possible to send in my G10 endura to be waved? Also, could the blade be either bead blasted, or otherwise have the spyderco spider removed? I don't want just half the spider sitting there after the wave, if that is possible.

Thanks,
Mark

 

[STR]

Would it be possible to send in my G10 endura to be waved? Also, could the blade be either bead blasted, or otherwise have the spyderco spider removed? I don't want just half the spider sitting there after the wave, if that is possible.

Thanks,
Mark

I really don't know about that. The Spyderco logo is deeper than it may appear and not just surface only so even the faint outline will probably remain if it was rubbed off. If you wish to have me Wave it simply follow the instruction for mailing to me found here as if you were ordering a clip but just skip the questions for clips and fill in your requests and or concerns in the notes section. Once printed off mail the knife and the form to me and I'll look it over. Thanks.

 

[mark greenman]

Ok, no problem, I still want it waved and will send it in soon.

 

[mark greenman]

Steve, I'm sorry, I'm finally getting around to sending out the endura.

Do you have a standard price for the wave, and should I include the MO with the knife, or do you prefer to check out the knife, and be paid via paypal.

Thanks,
-mark

 

[STR]

Steve, I'm sorry, I'm finally getting around to sending out the endura.

Do you have a standard price for the wave, and should I include the MO with the knife, or do you prefer to check out the knife, and be paid via paypal.

Thanks,
-mark

Paypal is just easier for me to electronically deposit than mailing in a check or money order so I prefer pay pal but take all.

Wave mods have always fallen in the $30 min shop fee price covering about one hour labor to do so that is where I priced them. Thanks
STR