Ganza Help - Specs/Measurements

M

Mr. Clean

Joined
Apr 26, 2007
Messages
2,114
Busse crew, any way I/we can get specs on the Ganza knives? Blade length and thickness please? I know I'm asking a lot with 29 knives offered but it would REALLY help me in the decision process.

Most specifically, knives number:
10
11
12
13
14
16
18
19
20
21
22
24
27
 
Me too. i suspect between one hog's preferences and another, it would be nice to have length & thickness on all.
 
Add me to that request. I have held off on some Ganzaaaa blades in the past because I was concerned they might be too thick! If there are skinnys in this bunch I will surely buy more.
 
I doubt you are going to get Specs, I'm sure the shop is busy getting the knives completed. As far as lengths go, they are modifications of the regular knife, so they will be approximately the same length. As far as thickness goes, since there were different thicknesses made, I guess you will have to take a chance on if it is thick or thin!
 
MikeH said:
Add me to that request. I have held off on some Ganzaaaa blades in the past because I was concerned they might be too thick! If there are skinnys in this bunch I will surely buy more.
Click to expand...

Same here.
 
randucci said:
I doubt you are going to get Specs, I'm sure the shop is busy getting the knives completed. As far as lengths go, they are modifications of the regular knife, so they will be approximately the same length. As far as thickness goes, since there were different thicknesses made, I guess you will have to take a chance on if it is thick or thin!
Click to expand...
I can work around not knowing the length but I think thickness is a must, especially in these EDC style knives.
 
randucci said:
I doubt you are going to get Specs, I'm sure the shop is busy getting the knives completed. As far as lengths go, they are modifications of the regular knife, so they will be approximately the same length. As far as thickness goes, since there were different thicknesses made, I guess you will have to take a chance on if it is thick or thin!
Click to expand...

I think you're right --- in that they're probably too busy to give us those little details.

But, I'm like Mike, I've refrained from purchase sometimes assuming they will be too thick.

My primary interest on the EDC sized blades is the handle thickness, not the blade. I figure almost any edge can be re-worked to be an efficient cutter. But if the Handles are of the "super-fat" type, there's no way to carry the blade IWB without it printing...

A simple spine shot would REALLY help :) :) But I won't hold my breath ;)
 
No SPECS! Less Competition! Really, I wouldn't buy ANY of them if you are worrried about thickness. Jerry is rampant with fat blades. Yeah, thats it, they are all fatties!!!
 
You must log in or register to reply here.
Back
Top