I picked one up the other day. It would make an excellent lightweight, portable toucher-upper. The corners meant to sharpen serrations might not quite fit into narrower serration grooves, but IMO for general resharpening when I don't want to carry my Sharpmaker around it's nice.
The pre-set angles in the rubber ends is actually a bit steep...I checked the angle, and it seems to fit exactly the chisel-ground edge bevel on my CRKT KISS, which is a rather steep angle for most double-ground knives. All one has to do is vary the angle according to each knife's edge angle.
Has anyone used theirs extensively, or have an opinion one way or the other?
Jim
[This message has been edited by James Y (edited 05-16-2000).]
The pre-set angles in the rubber ends is actually a bit steep...I checked the angle, and it seems to fit exactly the chisel-ground edge bevel on my CRKT KISS, which is a rather steep angle for most double-ground knives. All one has to do is vary the angle according to each knife's edge angle.
Has anyone used theirs extensively, or have an opinion one way or the other?
Jim
[This message has been edited by James Y (edited 05-16-2000).]