Glow In The Dark Liners???

[BARBARIAN-X]

Just got a Neoczen Camp Knife which has removable micarta scales so I'm looking for glow in the dark material approx 1-2mm thick that I could use as lines. Any ideas? Thanks!

 

[displacedtexan]

Are you wanting to make them or buy them?

If you want to buy some I'd get with Cuscadi...

 

[BARBARIAN-X]

I'll check out Cuscadi but I figured I'd make them myself. I just need to find the material then I'd just trace the scales, cut it out and trim it. Check the link to see what I'm trying to do. Thanks for the reply.

http://forum.neoczen.org/viewtopic.php?f=50&t=13063&sid=d1ed72d16586135b21d13f04cbae5cef&start=60#p597958

 

[peter r]

moonglow 2 from knifekits.com

 

[SteelSnob]

Cuscadi always charged a arm and a leg for anything I ever looked at.

 

[Tinbasher]

If you are not to fussed about having the scales removable you could just sand a bevel on them then mix glow in the dark powder with epoxy glue, fill the bevel with glue and sand it back, you will be left with a glow in the dark liner look.

Richard

 

[BARBARIAN-X]

Moon Glow II is almost 6mm thick...too thick.

 

[BARBARIAN-X]

This stuff would be great! 2mm thickness is pretty good but the sheet is too large @ 2m x 1m. Shipping overseas to my remote area would be retarded.

Glow acrylic sheet
http://www.curtisium.com/wst_page8.php?idx=1&file=images/2mm_x2mx1m_Acrylic_sheet.jpg&&ID2=OL9yM8

 

[BARBARIAN-X]

I think I'm goijng to just buy a couple of glow in the dark frisbees and cut liners or of them. i don't know why you can't get glow in the dark vulcanized fiber or similiar for liners.