GNiCr40Al4 dagger

Y

yangguangzhu

Joined
Mar 28, 2009
Messages
23
Hardness: 58rc
Blade length:95mm
Thickness: 4.8mm


bishou1.jpg


bishou2.jpg


bishou4.jpg


bishou5.jpg


bishou6.jpg
 
Last edited:
Nice,
I was hand sanding my GNiCr40Al4 hunter last night. I am going to try and finish it before the Harrisonburg show.
 
Mine's still sitting on the bench, I'm going to make folder blades out of it when I get the time. How's that alloy to sand, guys?

That's a sleek little knife. I want to hear more about the little fancy one, though.
 
Ooooh... GNiCr40Al4... sounds expensive. I'm still waiting for Aldo to come out with that high-end "Ch1Na" stuff.... lol

Beautiful job. I don't know if it accidentally slipped into the pics but that small damascus dagger is gorgeous... is there a thread on that one? I guess I can just do a search, right?

Rick
 
Rick Marchand said:
Ooooh... GNiCr40Al4... sounds expensive. I'm still waiting for Aldo to come out with that high-end "Ch1Na" stuff.... lol

Beautiful job. I don't know if it accidentally slipped into the pics but that small damascus dagger is gorgeous... is there a thread on that one? I guess I can just do a search, right?

Rick
Click to expand...

XieXie,that small dagger was made by offcuts of SE HIP damasteel.
 
Is there official composition listed for GNiCr40Al4 alloy?
I did find an older thread here on BF, but it only had approximate composition for the GNiCr40Al4.
 
You must log in or register to reply here.
Back
Top