Recommendation? Good custom fixed blade maker?

[Infi-del]

Looking for a knifemaker that does good double edged work, uses cpm 3V, and will make what I want... not push me towards one of their existing patterns. I don’t mind constructive input... but if I’m paying for it... I want what I want.

 

[jfk1110]

Check out Phillip Patton. He's A makers member here! Top shelf work, good prices easy going!!

Small damascus kwaiken

Steel: O1/L6 Turkish twist. The blade is hollow ground with an 10" wheel, with the tip section being flat ground. Hardness: 61 RC Length: 6-7/8" overall, with a 3-1/4" blade. Blade thickness: About 1/8" thick. Handle material: Black resin soaked wrap over maroon stingray skin. Sheaths...

www.bladeforums.com

All his links are on the bottom of this page I linked here!! Check out his stuff.. He's done two for me and I'm ecstatic!!!

 

[Wild Willie]

David Mary