Got a nice one today..

Joined
Mar 5, 2005
Messages
5,069
I just acquired a 7ot, other than patina on the bolsters and slight on the blade, it is mint. Factory edge, no scuffs, no wobble, 1095 blade. :thumbup: No box or sheath, but I can't complain. :D Any ideas as to what this is what this is worth, the age, etc?
 
Last edited:
G'day, you're 7-OT Cave Bear bears <pun intended> the early Tang stamping with a dash between 7 and OT and is Carbon Steel. The first7-OT's were issued in 1979 as I have one which is the 75th Anniversary model 1904-1979 and it bears the same early stamp. Later stampings had no dash being 7OT.
The high carbon steel models finished in 1995 and from 1996 had Schrade+ stampings = Schrade Stainless Steel. The 7-OT was the first large clip blade model in the OT line followed by the 6OT which did not have rear bolster.
Your knife is probably made in the 1980's.Both models of these knives are featured in my collector corner on Schrades R Us.Just to complicate things further the earliest model from 1979 had 4 handle pins and yours has three but having said that there are 2 models of 3 pin 7OT's <7-OT's> with the third pin in different locations on each....yours is the earliest position 3 pin! Check out Larry's corner and you will see all 3 models side by side....
Its worth what someone who needs an earlier model with 1095 high carbon steel blade will pay, but I suggest about US$30-$40 without box and bling. Hoo Roo
 
Last edited:
I would think that the 1095 steel would pretty formidable in that size of a blade. I have a few LB7s that are all stainless and they are great and see use each hunting season. I have often wondered though how well a 1095 blade in that size would compare when cleaning out a deer. Guess I'll have to keep a better eye out for some 1095s!

Chuck
 
Back
Top