Green Canvas Clothes for a Mini Manix

STR

STR

Knifemaker/Moderator
Moderator
Joined
Aug 27, 2004
Messages
12,955
Got this order in this morning and while out I at least started it by tracing and cutting out the new scales using the wife's band saw (shes still in bed) so I could take advantage of that nice new blade she has in it. Don't tell. I'm not supposed to use her equipment. Only when it needs fixing you see. :thumbdn: I was too lazy to change out the blade from my metal cutting one in my own saw to a better suited one for cutting micarta. No coffee yet this morning! I'm bad I know but hey, What she don't know....:D

I'll be doing this later and getting a Wave knocked out or two and mailed hopefully. Then hopefully about that time I'll get my UPS delivery of the parts needed to start on those Ouparators tomorrow. Thats the plan anyway. We'll see how it goes.

STR
 
Its a mini Manix not the full size.

Sooner or later I'll start on yours. Looks like a bit of a back step on the second which is fine. I may or may not finish it right now if thats the case.

STR
 
Problems with the pivot pins?

No hurry here. I am looking forward to making it my EDC, but waiting is half the fun.

Have fun,
Brett
 
Ok these are finished up and look much better than this shot will show I'm sure. If all goes as it should I'll hear in a few days that they went right on no problem. Keeping my fingers crossed until then though.

STR
 
You must log in or register to reply here.
Back
Top