Griptilian washers

[luke86]

Hey guys I was looking to replace the washers on my large griptilian. Benchmade wont send washers out and I was trying to avoid sending it in. Does any body know what dimensions the stock washers are. I was going to try to order some online if I could figure out what the size is. I found some on this site but I have no idea if the griptilian size is one of these sizes. Is there anybody that knows the dimensions of the stock washers? Thanks for any help.

http://www.knifekits.com/vcom/index.php?cPath=60_87_88

 

[loonybin]

Why would you want to replace them? Just polish them.

 

[luke86]

I over polished them.lol Now there too thin.

 

[luke86]

I'm thinking its one of the last two on this page. I'm not sure about the thickness. Can anybody confirm if this is the correct size and what the thickness is? I don't have a caliper and mine are thinner than stock anyway.

 

[Nbrackett]

OD = 0.600 ID = 0.225 and is 0.030 thick.

 

[luke86]

Thanks. Where did you find those specs?

 

[Nbrackett]

Thanks. Where did you find those specs?

Took apart one of mine and measured with my Brown & Sharpe calipers.

 

[luke86]

Took apart one of mine and measured with my Brown & Sharpe calipers.

Thanks a lot. Now if I could find some online that size I would be set. Anybody have any idea where I could find some?

 

[skil1977]

usaknifemaker look up on google

 

[luke86]

usaknifemaker look up on google

Thanks buts its been 2.5 years. I don't even have the knife anymore. I had already tried that site though.

 

[luke86]

double post