Heat Treat Stainless Foil and Anti Scale Solution

R

Rowlock

Joined
Jul 8, 2011
Messages
16
Good evening all and Happy Thanksgiving. I have a question if any of you all could help. I am looking for a place that may sell both stainless foil and anti scale solution so I don't have to buy from two different manufacturers and pay shipping twice. Brownells carries ATP 641 solution but they only sell foil by the sheet and it's a bit more there than on Grainger's website for a roll. Does anyone have any insight? Also, is there a differance in any of the SS foil that is sold, 321 or 304? Thanks in advance.


Brett
 
Wonder if someone can answer this:
Why is the 309/.002" foil on Enco listed as 2100 degree, and the same foil on USA Maker listed as 2240 degree?
 
Karl
I really don't know.I know several folks including myself that use the enco foil and I've always had good luck with it.Most everything I H/T is right at 2K or under so never thought to ask if there was any differance.
Stan
 
I use D2 a lot and have a couple rolls of 209 SS foil. If I have my blades super clean, sometimes I get spots where the foil sticks hard to the blades and sometimes needs ground off. If I take a rag with a bit of WD40 on it and wipe down the blades I get no foil stuck to my blades. I wrap each one separately. I do get a bit more discoloration that way, but, hand sand is next step anyway.
 
You must log in or register to reply here.
Back
Top