- Joined
- Apr 17, 2021
- Messages
- 1
I was sculpting the handle on a full tang Damascus knife (I'm not set up for corby's just yet) and I nicked the ricasso with a 60g belt. The blade is already polished and etched. Is there a specific technique I can use to get my finish back.
My current thoughts are to spot sand the small nicks with a very narrow sanding stick up to my finish grit, apply ferric with a q tip, then mask the handle and do a second coffee etch, still keeping the coffee level below the handle material.
Thank you in advance for any respones
My current thoughts are to spot sand the small nicks with a very narrow sanding stick up to my finish grit, apply ferric with a q tip, then mask the handle and do a second coffee etch, still keeping the coffee level below the handle material.
Thank you in advance for any respones