Hidden Tang Drop Point

[navman]

Finished up this sweet Hidden Tang Hunter in CPM4V (HT by Peters' to 64HRC). The blade is 3.75 inches with a 3.5 inch cutting edge, hollow ground on a 26" radius platen, so it almost looks flat ground. Hand satin finished to 400 grit with a rounded and polished spine. Handle is sculpted green linen micarta with an orange spacer against the stainless guard (416 SS), stainless small corby bolt and lanyard tube. The tang is nearly the full length of the handle and bedded in epoxy. OAL is just a hair over 8 inches. Rides in a hand sewn leather sheath with orange thread to match the spacer.

If I was heading to the woods today, this would be the knife on my hip!

 

[Dawkind]

Another great job….as is your leather.

 

[jfk1110]

.

 

[jfk1110]

Finished up this sweet Hidden Tang Hunter in CPM4V (HT by Peters' to 64HRC). The blade is 3.75 inches with a 3.5 inch cutting edge, hollow ground on a 26" radius platen, so it almost looks flat ground. Hand satin finished to 400 grit with a rounded and polished spine. Handle is sculpted green linen micarta with an orange spacer against the stainless guard (416 SS), stainless small corby bolt and lanyard tube. The tang is nearly the full length of the handle and bedded in epoxy. OAL is just a hair over 8 inches. Rides in a hand sewn leather sheath with orange thread to match the spacer.

If I was heading to the woods today, this would be the knife on my hip!

Beautiful....... Looks like the brother of my nessie you made..

 

[SharpBits]

Very nice, Josh. It looks super comfortable in the hand and very useful as a hunter and for EDC.