Ok, I know this must have been discussed a billion times, but I find too much into to sort through...
I have an XM-18 Gen 2 (3") and XM-18 Gen 4 (3.5") which are both non-triway running on teflon... can these easily be swapped out to PB washers? If so, where do I get those parts?
Awful questions, I'm sure... but I'm only a few months into this hobby, and my biggest knife surgery so far is replacing a scale. So, please give me a break.
I have an XM-18 Gen 2 (3") and XM-18 Gen 4 (3.5") which are both non-triway running on teflon... can these easily be swapped out to PB washers? If so, where do I get those parts?
Awful questions, I'm sure... but I'm only a few months into this hobby, and my biggest knife surgery so far is replacing a scale. So, please give me a break.
