How much would it cost spyderco to make this knife?

[Rawrzors]

full flat ground endura wave blade
with dlc coating.
s30v or m4 steel
the bi direction textured frn handles like on an endura
milled out stainless steel liners.
compression lock from a para2
polished bronze phosphate washers. with some holes drilled like the sebenzas to hold extra grease longer.
big lanyard holes with a stainless steel tube
really nice screws that wont strip out.
a deep carry dlc coated pocket clip

 

[chrisk91]

This would cost tens of thousands in my estimation. To my knowledge, the compression lock has never been used with frn, so they would have to make new molds for the scales. Then, Spyderco would have to make a new blade, one that would pose plenty of machining difficulties. It took years for Spyderco to get the compression lock right! It's nice to dream, but your knife will never happen.